Where are the floor springs prone to failure?
In what aspects are floor springs prone to failure? In the daily use of floor springs, due to the uneven quality of floor springs of different brands, some failures will inevitably occur.
Any industrial product may encounter some unavoidable unexpected problems during use and use, and the floor spring is no exception, so it is indispensable for users to understand some common faults of the spring.
Floor spring doors are more and more common now, but how to install and maintain floor springs, the following is a detailed explanation of the installation attention and daily maintenance of floor springs
1. The size of the slot is moderate, not too large or too small, too large will affect the appearance, too small, there will be less stable material, and the fixing will not be firm.
2. The position of the axis of the floor spring should be accurate, and it is best to use a plumb line or other tools to find a vertical line.
3. The cement or quick-drying powder used for stabilization should have a suitable viscosity to ensure the strength of the stable spring.
4. Ensure the level of the floor spring and the vertical of the top shaft
Facing these problems, do we have a good solution?
Common fault 1, floor spring oil leakage problem: if the product has quality assurance or the product itself is replaced with the manufacturer, the floor spring with a constant temperature device generally does not leak oil. If it is a no-name brand or an OEM product, there is no guarantee of oil leakage. Be careful when installing. The speed control valve cannot be screwed too loose or it will cause oil leakage. Improper installation can also cause oil leakage.
Common fault 2, attention to the opening angle of the floor spring: the opening angle should be controlled according to the product manual of the floor spring. If the door is opened excessively, the oil circuit in the floor spring will be damaged. Seriously, it will cause the shaft head to break.
Common fault three, the door closing angle of the floor spring is not in place: the shaft head of the floor spring is deviated from the position, and the left and right adjustment screws of the floor spring are adjusted tightly during installation.
Common fault four, the problem of ground spring broken spring: It can be understood literally, that is, the internal spring is broken, mainly these four kinds of problems.
In order to greatly reduce the possibility of the above-mentioned problems of the floor spring, it is recommended: 1. We should start with the installation of the floor spring itself. In fact, the quality of the floor spring itself is not too much, and many of them are installation accuracy problems. 2 When choosing the floor spring, it is appropriate to choose the appropriate door width and weight.
Of course, the point is that after finally grooving and securing the floor spring, wait until the cement or quick-drying powder has sufficient strength before installing the door body to avoid rework caused by the displacement of the floor spring.